Appliance Repair in Ogden, UT

A broken appliance throws off the whole household. A warm refrigerator means spoiled groceries, a dead washer means a growing pile of laundry, and a dishwasher that won't drain leaves you washing everything by hand. Ogden Appliance & HVAC provides appliance repair in Ogden, UT and the surrounding communities, with honest diagnosis and a plain-language explanation of the problem and the cost before we start.

Most appliance problems come down to a single failed part, such as a pump, belt, igniter, sensor, valve, or control board, and replacing that part is often far less expensive than buying a new appliance. When a repair doesn't make financial sense, we'll tell you that too, so you can decide whether to fix it or replace it.

Jump to:

• Refrigerators
• Washers
• Dryers
• Dishwashers
• Ovens & ranges
• Microwaves
• Garbage disposals
• Brands

Refrigerator repair in Ogden

Refrigerators run around the clock, so small problems tend to get worse quickly. Common refrigerator repair calls in Ogden include a fridge that isn't cooling, a freezer that's frosting over, water leaking onto the floor, an ice maker that quit, and loud clicking, buzzing, or rattling from the back of the unit.

Many cooling problems trace back to a failed evaporator or condenser fan, a defrost system fault, dirty condenser coils, or a bad start relay. We check the whole system, not just the symptom, so the same problem doesn't return a week later. Ice maker and frost-related issues are frequent requests for Samsung refrigerator repair in Ogden, and we regularly handle cooling and defrost problems on LG, Whirlpool, GE, and Frigidaire models as well.

Before you call, make sure the vents inside the fridge aren't blocked by food and that the condenser coils aren't caked in dust. Those two quick checks solve more warm-fridge problems than you might think.

Washer repair in Ogden

Washer repair in Ogden usually starts with one of a few complaints: the machine won't drain, won't spin, leaks, shakes violently, or stops mid-cycle with an error code. Front-load and top-load washers fail in different ways, and we repair both, including drain pumps, lid and door locks, suspension parts, inlet valves, and control boards.

Hard Wasatch Front water plays a big role here. Mineral scale builds up in inlet valves, pumps, and heating elements, and it can trap detergent residue that leads to musty odors in front-load machines. During the repair, we'll point out any buildup we find and suggest simple habits that help, like monthly cleaning cycles, wiping the door gasket, and using the right amount of high-efficiency detergent.

Dryer repair in Ogden

A dryer that runs but doesn't heat, takes two or three cycles to dry a load, squeals, or won't start at all is one of our most common calls. We handle dryer repair in Ogden for both electric and gas dryers, including heating elements, gas igniters and valves, thermal fuses, belts, rollers, door switches, and timers or control boards.

Long drying times are often a venting problem rather than a dryer problem. A clogged or crushed vent makes the dryer work harder and can lead to overheating. We check airflow as part of every dryer repair and let you know if the vent run needs a thorough cleaning.

Dishwasher repair in Ogden

Dishwasher repair in Ogden often comes down to drainage, leaks, or dishes that come out dirty or spotted. Clogged filters, failed drain pumps, worn door gaskets, bad inlet valves, and faulty heating elements are frequent culprits.

Hard water is a major factor for dishwashers in our area. Scale coats spray arms and heating elements, leaves a cloudy white film on glasses, and can clog small spray holes over time. Along with the repair, we'll show you where the filter is, how to clean it, and whether rinse aid or a periodic descaling cycle would help. Bosch, KitchenAid, Whirlpool, GE, and Samsung dishwashers are all regulars on our repair list.

Oven and range repair in Ogden

Whether you have a gas range, an electric or induction cooktop, or a wall oven, we diagnose problems like an oven that won't heat, uneven baking, burners that won't light, a stuck self-clean lock, and temperatures that run hot or cold.

Typical oven repair in Ogden involves replacing bake or broil elements, igniters, temperature sensors, surface burner switches, or control boards. On gas appliances, we confirm proper ignition and safe operation before we leave. If you ever smell gas, leave your home and call your gas utility right away, then call us for the repair.

Microwave repair in Ogden

We repair over-the-range and built-in microwaves that won't heat, have an unresponsive keypad, a turntable that won't spin, or a light or vent fan that stopped working. Over-the-range models also serve as your stove's vent hood, so a failed fan or light is worth fixing.

Please don't try to open a microwave yourself. Microwaves contain a high-voltage capacitor that can hold a dangerous charge even after the unit is unplugged. Countertop microwaves are often cheaper to replace than to repair, and we'll tell you honestly if that's the case.

Garbage disposal repair in Ogden

A disposal that hums but won't turn, leaks from below, drains slowly, or keeps tripping its reset button can often be repaired. We clear jams, check the switch and electrical connection, and fix leaking connections.

If the unit is rusted through or the motor has failed, we can replace it with a properly sized new disposal. To prevent jams, keep grease, fibrous foods like celery, and coffee grounds out of the disposal, and run cold water whenever it's on.

Brands we repair

We repair most major household appliance brands. Whether you need Samsung refrigerator repair in Ogden, an LG washer that won't spin looked at, or a Whirlpool dryer that's stopped heating, we're ready to help.

• Samsung
• LG
• Whirlpool
• GE
• Maytag
• Frigidaire
• KitchenAid
• Bosch
• Kenmore

Don't see your brand? Ask anyway. Many appliances share parts and designs across brands. Kenmore appliances, for example, have been built by other manufacturers, so once we have the model number we can usually track down the right parts.

Signs your appliance needs repair

• Unusual noises, such as grinding, squealing, banging, or loud humming
• Water leaking or pooling under or around the appliance
• Error codes or blinking lights that keep coming back
• Burning smells, tripped breakers, or scorch marks (unplug the appliance and call us)
• Longer cycles or poor results, like damp clothes or dirty dishes
• A refrigerator or freezer that feels warmer than it should

What happens when you call

1. Tell us what's happening. Call us or schedule appliance repair online. Include the brand, the model number if you have it, and the symptoms.
2. We schedule a visit. We'll find a time that works for you and confirm the appointment.
3. Diagnosis and a clear price. The technician inspects the appliance, explains the problem in plain language, and gives you the repair cost before starting.
4. The repair. Many repairs are finished in one visit. If a part has to be ordered, we'll tell you when to expect it and schedule the return trip.
5. Testing and cleanup. We run the appliance to confirm the fix and leave your space clean.

Appliance repair in nearby cities

Along with Ogden, we provide appliance repair in Layton, UT, Roy, North Ogden, South Ogden, Riverdale, Clearfield, Syracuse, and Kaysville. Read more about service in Ogden or see every city on our service areas page.

Planning a bigger project? We also handle HVAC installation in Ogden, including central air conditioners and smart thermostats, plus UV light installation for your heating and cooling system.

Appliance repair FAQ

Is it worth repairing my appliance, or should I replace it?

It depends on the appliance's age, its overall condition, and the repair cost compared with a new unit. A common rule of thumb is to consider replacement when a repair would cost about half the price of a comparable new appliance, especially on an older unit. We'll give you an honest recommendation either way.

Do you charge a diagnostic fee?

We'll explain any diagnostic fee when you schedule your visit, before we come out. We also give you the repair price before any work begins, so there are no surprises.

How quickly can you come out?

Scheduling depends on the day's workload, but because we're based in Ogden, we can often reach nearby homes quickly. Call us and we'll give you the earliest available time.

What information should I have ready when I call?

The brand, the model and serial number (usually on a sticker inside the door, on the back, or under the lid), and a short description of the problem, including any error codes.

Why does my dishwasher leave white spots on my dishes?

White spots and film are usually caused by hard water minerals, which are common along the Wasatch Front. Using rinse aid, cleaning the filter, and running a descaling cleaner now and then can help. If spotting continues, a weak heating element or clogged spray arms may need repair.